MELT FLOW INDEXERS


Melt Flow Indexer (Plastometer), often known as Melt Flow Index Tester is used in the laboratory to measure the melt flow index (MFR / MFI) in the unit of g/10min and the melt volume flow rate (MVR) in the unit of cm³/10min of thermoplastic polymer in the form of pellets, powder or fine granules. The Melt Flow Index Testers are designed to perform melt flow rate testing according to EN ISO 1133 and ASTM D1238 standard. The testing instrument can be configured individually by means of various automated accessories and many options to adapt to applications.

Melt indexer with automatic weight selection can carry out tests according to ISO 1133 and ASTM D 1238, procedures B, as well as ISO 1133 and ASTM D 1238 procedure C for the "Half Height / Half Diameter" standard and procedure D for the FRR test (Flow Rate Ratio) and ASTM D 3364. Also the manual procedure A is possible to perform.

The IV Tester is to determine the intrinsic viscosity (IV), which is also called solvent viscosity (SV), without the use of chemical solvents. Intrinsic viscosity is used to characterize the average molecular weight of PET and PA-based polymers.

Available in: Indonesia, Singapore, Malaysia, Thailand and Vietnam



Back to Plastic & Rubber Testing

Melt Flow Indexers Product


IV Tester

The IV TESTER is a simple device for the determination of Intrinsic Viscosity (IV or SV value), with no chemical solvents are used. This IV Tester is used in particular for quality control of polyester (PET) or polyamide (PA).

Read More >>>

MI-2 series

The GÖTTFERT Mi-2 is the basic model with one weight where only a few measurements are needed during QC checking.

MODEL: MI-2.1, MI-2.2, MI-2.3

MI-3

The GÖTTFERT Melt Flow Index Tester Mi-3 is a semi-automatic instrument that is able to measure the MFR and MVR.

Read More >>>

MI-40

The GÖTTFERT Mi-40 is the most advanced model Melt Flow Index Tester with automatic weight selection.

Read More >>>

MI-40 Visco

The mi40 Visco is equipped with additional features that allow it to perform measurements based on the ISO 11443 standard, which is commonly used for capillary rheometers

Read More >>>

MI-Robo

The GÖTTFERT Mi-Robo is a fully automatic melt flow rate measurement equipment which performs all the testing process automatically according to ISO1133 and ASTM D1238 standards.

Read More >>>

TOP